I. Preparations

1. Essential Tools

• Core Device: KW100 Bluetooth Smart Key Programmer (ensure sufficient power; can be powered via Type-C interface connected to a mobile phone or charger)
• Key Carrier: LT20 Series Smart Key PCB Board corresponding to the vehicle model (no need to distinguish specific models; KW100 automatically adapts)
• Auxiliary Tools: Mobile phone (with LONSDOR official APP installed, supporting iOS/Android; downloadable by scanning the QR code in the device manual), vehicle OBD connection cable
• Others: LT20 key shell (for assembly after programming)

2. Environment & Vehicle Requirements

• Operating Environment: Keep away from other smart keys (no interfering devices within 2 meters) to avoid wireless signal interference
• Vehicle Status: Stable battery voltage (recommended 12V normal voltage), vehicle parked in a safe area, all electrical devices turned off
• Pre-check: Confirm KW100 firmware and mobile APP are up-to-date (automatic update detection available in the APP)

III. Key Verification & Assembly

1. Function Test
   • Startup Verification: Bring the programmed LT20 key board close to the vehicle ignition switch, turn on the ignition switch; the normal lighting of the instrument panel indicates effective startup function
   • Remote Control Test: Test functions such as locking, unlocking and trunk opening to confirm consistency with custom configurations
   • Additional Verification for All Keys Lost Scenario: Try to start the vehicle to confirm the engine runs normally without anti-theft alarm prompts
2. Completion of Assembly
   • Install the verified LT20 key board into the corresponding shell, press to fix it in place, and it can be used as a normal smart key
   • To clear the information of the original old keys (for all keys lost scenario), select 「Key Management」 → 「Clear Extra Keys」 in the APP and complete the operation according to the prompts (vehicle needs to be in power-on state)

IV. Notes & Troubleshooting

1. Key Notes

• Do not disconnect the Bluetooth connection or OBD line during programming, otherwise data writing will fail
• The LT20 key board does not need to pre-distinguish frequency and chip type; KW100 can automatically adapt and convert
• The generated key supports all original vehicle smart functions (including keyless entry and one-key start), consistent with the original factory key

2. Common Troubleshooting

• Bluetooth Pairing Failure: Turn off and restart mobile phone Bluetooth or reboot the KW100 device; ensure the distance between the two is no more than 1 meter
• Data Reading Failure: Check if the OBD connection cable is firmly inserted and the vehicle battery voltage is normal; try again after troubleshooting
• Failure to Start After Key Generation: Confirm the correct vehicle model selection and matching between the LT20 model and the vehicle; use the 「Rewrite」 function in the APP to program again
• Inconsistent Button Functions: Re-enter the 「Button Configuration」 interface in the APP to adjust without re-generating the key

Summary